Building an elevated milking stanchion
(Note: This post may take a minute to load, it is very picture heavy)
As I’ve mentioned before, we were planning on building a raised milking stanchion for Gertie.
We Farmer Derek got to work on it and finished it up last weekend. I am so happy, it is perfect. I wanted to share how we did it with you. If you need or want to build a raised stanchion I hope ours will encourage you and give you great ideas for your own design!
We have been doing all of our homestead projects for Gertie on a very tight budget and have been cutting our own lumber with our Alaskan Chainsaw Mill for as much as possible. Farmer Derek was given some 5″x5″ treated lumber posts (huge blessing!) so we used them for the legs of the stanchion. The treated lumber is important for the parts that will be on the ground so they don’t rot. Farmer Derek was able to saw out the rest of the lumber with the help of our friends David and his dad Russel. We haven’t had to invest any money in the stanchion other than the nails for it.
(Note: Sorry, I do not have any pictures from before Farmer Derek began assembling the stanchion.)
Farmer Derek Started out but building the frame for the stanchion using the 5″X5″ posts and 2″X6″ boards. He then added the 2″X4″ platform plank floor boards. After the platform was completed he started building the “on ramp”. He took 2″X”6 boards and sawed them at an angle on one end so they would lay nicely on the ground.
We made the stanchion about 18″ off of the ground. We built a ramp going straight up to the stanchion and then one that comes down from the head gate. We wanted to the ramps to have plenty of a slope so Gertie won’t slip on them. We will be adding some rubber mats for extra grip as well. The platform is 34″ wide and very well braced. It has 1 1/2″ thick boards for flooring. We also put two side rails on each side so there isn’t much “airspace” for risk of falling off. A cow falling off of a platform would be a REALLY bad thing for all involved. We also placed a board on each side of the platform at the bottom so that if her foot were to get too close to the edge it can’t go over and cause a major problem. The head gate is 7 1/2″ wide when it is in the locked position. We checked around for head gate dimensions and that seemed to be the magic number for Jerseys. It is a perfect fit for Gertie.
The design is so great for our situation. The “off ramp” leads straight into the stall side of the barn so when we finish up with milking she can go straight out. Gertie walks right up on the stanchion like she has been doing it forever. She happily eats her feed while I milk to my little heart’s content. It is bovine happiness out there. The barn is currently about 60% completed. I’ll be writing a post about it when it is finished.
The stanchion looks so nice in my milking parlor. Yes, I have a milking parlor! I love the way that sounds! I’m just a wee bit giddy over here with all of this cow milking stuff.
More posts like this: